电子干燥柜 电子防潮柜使用注意事项

电子干燥柜  电子防潮柜使用注意事项-苏州三清仪器有限公司发布

注意事项如下：

1. 每次开门时间尽可能短，推荐控制在1分钟之内。Every time of opening the door should be as short as possible, you'd better control it in 1minute.
2. 请尽量不要断电，以免影响使用
Please try not to switch off the power, so as to avoid impairing its use.
3. 当物体放入防潮箱内时，如果物体本身所含湿气较大，防潮箱内湿度将会上 升，也许要花1至2天湿度才会下降，对于含有包装纸或布类物件，湿度下降时间要更长一些。
When parts are placed inside the cabinet for storage, the humidity will rise due to the moisture contained in the parts, and it maybe take about 1 to 2 days for de-humidity, if the parts that contain a lot of paper or cloth, the humidity drop down to normal status for more than 2 days.
4. 湿度设定后,本产品对设定值有记忆功能,即使断电也无须再设定。
The product has the memory function, after setting the humidity, even if cut off the power, we do not set it again
5. 湿度显示值误差±3%RH,采用进口传感器,温度显示误差为±1度左右。
The error of humidity display value is ±3%RH and the temperature display error is about ±1℃. The humidity sensor is imported sensor
6. 不要遮盖背部除湿机芯散热孔。
Do not cover the de-humidity device's exhaust vent located on the back of cabinet.
7. 如果停电24小时以上,箱内存放物品建议转移。
If the power has been cut off more than 24 hours, we suggest you changing the parts kept in the cabinet.
8. 配防静电台垫的请连接好线。防静电产品脚轮防静电。无论地坪防不防静电，建议连接静电接地线。
Please connect the electric line of preventing static electricity pad.

9. 除湿期间，外部叶片门打开，除湿机芯表面温度略高，这是正常的，请不要误认为是除湿机芯故障。
During de-humidity period, the outer shutter will be open, and the surface temperature of de-humidity device will be rise several degrees, and the area around the de-humidity device will get warm, however this is normal and there is nothing wrong with the dry cabinet.
10. 请使用220V/50HZ电源。
Please use 220V/50HZ power supply.
11. 湿度不下降时请让防潮箱停电并重新启动运行12小时以上,箱内湿度下降则正常。
If the humidity dose not drop down, please switch off the power and restart it again more than 12 hours, if the humidity has drop down, the dry cabinet is running well